Technical characteristics
Technical characteristics:
- Hermetic compressor
- Anti-vibration compressor brackets
- Air condensation
- Galvanized powder coated sheet steel body
- Evaporator body of aluminium-magnesium alloy
- Evaporator of copper pipes and aluminium fins
- Condenser of copper pipes and aluminium fins
- Automatic restarting low pressure switch
- Automatic restarting high pressure switch
- Compressor timer management to avoid too near start-ups
- Axial fan
- Condensation control device *
- Thermic compressor protection
- Thermostatic expansion valve with external equalization *
- Suction pressure relief valve (only for low temperature models)
- Dehydrator filter
- Suction-side liquid separator
- Defrost hot gas solenoid valve
- Automatic hot gas defrosting
- High and low pressure ¼” pipe plugs
- Condensation outlet siphon
- Condensation outlet resistor (only for low temperature models)
- Cold room ceiling light and power source cable with related protection via fuse
- Ambient temperature probe
- Defrosting end temperature probe
- Condensation control temperature probe
- Connecting cable for door resistor with protection 4A fuse (only for low temperatures models) and related protection with fuses
- Connecting cable for door micro switch to turn off the system and to turn on the light at door opening
- Transformer
- Digital display with temperature indicator at one decimal
- On/Off switch
- Cold room light switch
- Running state display: cold – defrosting – evaporator fans – alarm status
- Programming keys
- Alarm display
- Manual defrosting key
- Acoustic alarm
- High temperature alarm
- Low temperature alarm
- High temperature alarm dirty condenser
- Low temperature alarm condenser
- Open door alarm
- High / Low pressure alarm
- Defrosting end alarm because of time-out
- Alarm ambient temperature probe defect
- Alarm defrosting end temperature probe defect
- Alarm condensation control temperature probe defect
- Timer emergency running in case of these events:
– Ambient temperature probe defect
– Defrosting end temperature probe defect
– Condensation control temperature probe defect
– Cold room door open (if there is door micro switch) - Pre-set connection for Frigotel® supervision
Optional:
- Door micro switch
- Water condensation with liquid receiver, pressure control valve, pipe connection ½”
- Different voltage
- Tropicalised Version
- Condenser fan speed regulator
- Voltage display for machine stop in case of incorrect power supply
- Electronic module for the connection to Frigotel® supervision system
- Evaporator with cataphoretically painting
- Condenser with cataphoretically painting
* depending on model
Destined use
Cibin’s refrigerating equipment is classed as food and agricultural machinery (MACHINES DIRECTIVE 2006/42/EC), destined for the treatment
of food products.
The machine is designed for the conservation of foods and/or “fresh” products at temperatures indicated in annexes.
It has been designed to work in ambient temperatures from +16°C to +43°C (class T).
It has been designed to maintain a set temperature in a refrigerated cold room suitable for such uses.
The machine is not designed for use in cold rooms situated outside.
The machine is not designed for installation and use in an environment where there is risk of explosion.
Any use other than that permitted shall be considered improper, and in this case the Manufacturer will decline all liability.
The machine is not designed for the conservation of products, which produce corrosive substances.
Models
R452A
R452A – 50Hz – TN
R452A – 50Hz – BT
R452A – 60Hz – BT
R452A – 50Hz – TN – W
R404A
TN – R404A – 50 Hz
BT – R404A – 50 Hz
TN – R404A – Water-condensed units
* Max ambient temperature: + 43°C
Ta: Ambient temperature
Tc: Cold room temperature